A Piercing Technique for Glass Sheets by the Impact Compression of a Viscoplastic Pressure Medium
-
- KUROSAKI Yasushi
- Faculty of Engineering, Mie University
-
- FUJISHIRO Ikuya
- Faculty of Engineering, Mie University
-
- MIYAKE Yoshiyuki
- Tateishi Electric Co., Ltd.,
-
- FURUKAWA Yasushi
- Nihon Gaishi Co., Ltd., Chita Factory
この論文をさがす
抄録
An improved method for piercing a circular hole in a glass sheet, difficult to achieve by conventional punching or drilling, is investigated by employing a manufacturing process using the impact compression of a viscoplastic pressure medium. Since the method previously proposed by the authors is not appropriate for a large ratio of hole diameter to workpiece thickness, an improvement is attempted in which two techniques are proposed: a method based on the delay phenomenon in the elastic response of workpieces and a differential pressurization method. Results show that both methods are useful. The latter method is also effective for improving the accuracy of the produced hole.
収録刊行物
-
- JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
-
JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry 32 (2), 330-337, 1989-06-15
一般社団法人日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1571135652072020480
-
- NII論文ID
- 110002505114
-
- NII書誌ID
- AA10680610
-
- ISSN
- 09148825
-
- Web Site
- http://hdl.handle.net/10076/8687
-
- 本文言語コード
- en
-
- データソース種別
-
- CiNii Articles