DSPによるダイナミックレンジコントローラの実現法
書誌事項
- タイトル別名
-
- Realization of dynamic range controllers on a digital signal processor for audio systems
この論文をさがす
抄録
This paper describes a new design method of dynamic range controllers, such as compressor, limiter, expander and noise gate, on a DSP for digital audio systems. For the compressor, we have previously proposed an efficient implementing method on DSP by calculating the polynomial expression to approximate the power transformation. Based on the approximation algorithm, we extend the positive compression ratio to the negative compression ratio for the compressor. Then, we design an expander based on the facts that the ideal compression characteristic could be obtained by applicaiton of a polynomial expression. By defining an expansion (downward expansion) characteristic with two threshold levels, the gain for getting the expansion may be decomposed into a gain of an upward expansion with an integer expansion ratio, a gain of a compression and gain shift. By this method, the ideal input-output characteristic can be achieved by using seven-order polynomial expression for dynamic range control of 50 dB. The digital signal procesing on DSP is about 130 steps for the compressor, and 120 steps for the expander with a given expansion ratio equal to or smaller than 15.
収録刊行物
-
- Journal of the Acoustical Society of Japan ?
-
Journal of the Acoustical Society of Japan ? 16 (6), 353-362,
Japan Acoustical Society of Japan
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1543105995110682752
-
- NII論文ID
- 110003105467
-
- NII書誌ID
- AA00256597
-
- 本文言語コード
- en
-
- データソース種別
-
- NDL-Digital
- CiNii Articles