An amplitude-phase-modulation (APM) using a shear horizontal (SH) plate-mode wave device.
-
- Mizutani Koichi
- Institute of Applied Physics, University of Tsukuba
-
- Wakatsuki Naoto
- Department of Electrical and Electronic Engineering, University of Okayama
-
- Yoshida Hirofumi
- Institute of Applied Physics, University of Tsukuba
-
- Nagai Keinosuke
- Institute of Applied Physics, University of Tsukuba
書誌事項
- タイトル別名
-
- amplitude-phase-modulation APM using a
この論文をさがす
抄録
A method of realizing an amplitude-phase modulation using a travelling type ultrasonic device is described. A shear horizontal (SH) plate-mode wave device is composed of four interdigital transducers (IDTs). The first and the forth IDTs are used for the carrier signal input, and device output. The another two IDTs located at the central part of the SH-wave device are used as an attenuator and a phase-shifter for amplitude and phase modulation, respectively. The operation principle that is analyzed with the equivalent circuit model for the amplitude-phase modulator, is given with experimental confirmation. At the frequency of 1.20MHz, the device performs as amplitude modulator and phase modulator, simultaneously.
収録刊行物
-
- Journal of the Acoustical Society of Japan (E)
-
Journal of the Acoustical Society of Japan (E) 18 (5), 261-266, 1997
一般社団法人 日本音響学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282680066681088
-
- NII論文ID
- 110003105497
-
- NII書誌ID
- AA00256597
-
- ISSN
- 21853509
- 03882861
-
- NDL書誌ID
- 4287967
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- NDL-Digital
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可