衝撃曲げモーメントを受ける異種材料スカーフ接着継手の有限要素応力応答解析

• 志村 穣

  山梨大学大学院

• 樋口 泉

  甲府城西高等学校

• 沢 俊行

  山梨大学

書誌事項

タイトル別名

• Finite-element Stress Response Analysis of Adhesive Scarf Joints with Dissimilar Adherends Subjected to Impact Bending Moments.
• ショウゲキ マゲ モーメント オ ウケル イシュ ザイリョウ スカーフ セッチャク ツギテ ノ ユウゲン ヨウソ オウリョク オウトウ カイセキ

抄録

The stress wave propagation and the stress distribution in adhesive scarf joints with dissimilar adherends subjected to impact bending moments are analyzed in an elastic deformation using three-dimensional finite-element method (FEM). An impact load is applied to the joint by dropping weight. The one side of the adherend is fixed and the other side of the adherend is subjected to an impact load. FEM code employed is DYNA3D. The effects of scarf angles of the adherends, the adhesive thickness and Young's modulus of the adhesive, the combinations of materials of the adherends on the stress propagation and distributions at the interfaces are examined. The scarf angles are changed from 15 to 90 degrees. It is found that the maximum value of the Mises' equivalent stress σ_M appears at the interface between the adhesive layer and the adherend made of mild steel, and it is independent of the combinations of the adherend materials. In the case where the scarf angle is 45 degree, the maximum value of the Mises' equivalent stress σ_M is minimal. The stress σ_X is the greatest in all of stress components. The maximum value of the Mises' equivalent stress σ_M increases as the adhesive layer thickness and Young's modulus of the adhesive increase. It is seen that the position where the maximum value of the Mises' equivalent stress σ_M occurs moves toward edge of the adhesive interface as the thickness and Young's modulus of the adhesive increase. In addition, experiments were carried out to measure the strain response of the adhesive scarf joints subjected to impact bending moments using strain gauges. A fairly good agreement is seen between the analytical and the experimental results.

収録刊行物

• 溶接学会論文集

  溶接学会論文集 19 (4), 693-701, 2001

  一般社団法人 溶接学会

キーワード

• Stress response analysis
• adhesive scarf joints
• dissimilar adherends
• adhesive layer
• scarf angle
• FEM
• three-dimensional
• impact bending moments

詳細情報

• CRID: 1390001204722396800
• NII論文ID: 110003422136
• NII論文ID: 130003934629
• NII書誌ID: AN1005067X
• DOI: 10.2207/qjjws.19.693
• ISSN: 24348252
• ISSN: 02884771
• NDL書誌ID: 5970932
• Web Site: https://ndlsearch.ndl.go.jp/books/R000000004-I5970932
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • NDL
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可