この論文を読む／探す
抄録
An implant tablet of ketoprofen (KP) was developed in order to achieve its sustained supply for approximately one week, and its release was evaluated in vitro and in vivo. Implant tablets (30mg) containing 1 and 5mg of ketoprofen, prepared using poly(DL-lactic acid-co-glycolic acid) copolymer (PLGA; MW 10000; lactic acid:glycolic acid=1:1 (mol/mol)) as a matrix, exhibited similar week-long sustained release in vitro. Plasma concentration was monitored after the implant tablet (5mg of KP) and a KP solution (0.5mg of KP) were administered subcutaneously to rats, and in vivo release rate was analyzed by deconvolution. The release rate from the implant tablet was faster in vivo than in vitro in the initial phase, but much lower in vivo than in vitro in the later phase. The plasma level decreased to the level less than the minimal effective concentration at 96h after administration. However, the calculated plasma concentration given by convolution based on in vitro release rate was more than 7 times greater than the minimal effective concentration even at 96h after administration. As the implant displayed the discrepancy between in vitro and in vivo release rates, the improvement of the in vivo release rate is required.
