-
- 樋口 大輔
- 昭和大学歯学部第一歯科補綴学教室
書誌事項
- タイトル別名
-
- The Accuracy of Working Casts for ITI Implants.
- ITIインプラントについて
この論文をさがす
抄録
The purpose of this study was to investigate and compare the accuracy of working casts made from two methods (transfer-pin type and stone type). In addition, the cause of distortion of working casts was examined, impressions were made from an implanted metallic model of a simplified mandibular dentition, and working casts were measured using the three-dimensional measuring microscope.<BR>The results were as follows:<BR>1. The distortion of reference points, other than in the implanted area, for both the transfer-pin type and the stone type casts had a similar tendency.<BR>2. In the implanted area, the reference points on the occlusal screw had a different tendency with relation to the amount of distortion and direction, the height and inclination of the abutments had different tendencies, and the stone type casts were more accurate than the transfer-pin type casts.<BR>3. The existence of impression spacers and transfer-pins and the error of operation must be considered as probable causes of the differences of accuracy of the two types of casts.<BR>4. The working casts made from the new method (using an implant head) were as accurate as the stone type casts.
収録刊行物
-
- 日本補綴歯科学会雑誌
-
日本補綴歯科学会雑誌 40 (4), 660-671, 1996
社団法人 日本補綴歯科学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204408229760
-
- NII論文ID
- 110003858494
-
- NII書誌ID
- AN00197911
-
- ISSN
- 1883177X
- 03895386
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可