Shear Bond Strengths of Four Resin Bonding Systems to Two Silica-based Machinable Ceramic Materials

DOI NDLデジタルコレクション Web Site 被引用文献2件 参考文献45件
  • KAMAD Kohji
    Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Biomedical Sciences
  • YOSHIDA Keiichi
    Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Biomedical Sciences
  • TAIRA Yohsuke
    Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Biomedical Sciences
  • SAWASE Takashi
    Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Biomedical Sciences
  • ATSUTA Mitsuru
    Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Biomedical Sciences

この論文をさがす

抄録

The purpose of this study was to evaluate the bond strength between four bonding systems (GC Ceramic Primer and Linkmax HV (CP+LM), Clapearl Bonding Agent and Clapearl DC (CBA+CL), Clearfil Mega Bond Porcelain Bonding kit and Panavia F2.0 (MB+PF), and RelyX Ceramic Primer and RelyX ARC (RC+RA)) and two machinable ceramics (Vitablocs Mark II, VMII and GN-I ceramic block, GNI). Shear bond strength was determined after 24-hour immersion in water or after thermocycling of 20,000 cycles. It was found that the post-thermocycling bond strength of each bonding system to VMII was significantly higher than that to GNI. VMII showed no significant differences between CP+LM, MB+PF, and CBA+CL – the values of which were higher than that of RC+RA. Regarding GNI, CP+LM showed the greatest bond strength after thermocycling among the four bonding systems used. It was concluded that the crystalline phase of the ceramics used might have an effect on bond strength.

収録刊行物

被引用文献 (2)*注記

もっと見る

参考文献 (45)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ