Effect of Inhomogeneous Mixture Properties on CI Combustion in a Schnurle-Type Gasoline DI Engine

    • KIM Seok-woo
    • Graduate school of Science and Technology, Chiba University
    • MORIYOSHI Yasuo
    • Department of Electronics and Mechanical Engineering, Chiba University

Abstract

The authors have performed experiments on compression-ignition (CI) for a singlecylinder Schnurle-type two-stroke gasoline direct injection (DI) engine which employs a variable exhaust port, area, and deduced two presumptions from the experimental results. Firstly, the spatial distributions of fuel concentration and in-cylinder gas temperature are indispensable to enable CI operation under stratified charge conditions, because CI operation is not possible in a DI system although the necessary conditions of the scavenging efficiency and the in-cylinder gas temperature for the initiation of CI in homogeneous charge conditions are satisfied. Secondly, it is possible that flame propagation occurs in stratified charge CI conditions, because the combustion period in the later stage after 80% mass burned becomes longer than that with homogeneous charge CI combustion. In this report, in order to verify the above two presumptions deduced from experiments, the gas exchange process and mixture formation process were numerically analyzed, and the initiation conditions of CI were estimated using a CHEMKIN application. As a result, in case of CI with a late injection timing in DI system, it was found that CI was possible because high temperature but no fuel region and low temperature but rich fuel region exist in the cylinder due to inhomogeneous spatial distributions of fuel and temperature. Also, in case of CI with a late injection timing, the flame propagation was possible in the low-temperature and diluted rich region. Thereby, the two presumptions deduced from the experimental results were validated from the numerical analysis results.

Journal

JSME international journal. Ser. B, Fluids and thermal engineering   [List of Volumes]

JSME international journal. Ser. B, Fluids and thermal engineering 48(3), 597-602, 2005-08-15  [Table of Contents]

The Japan Society of Mechanical Engineers

References:  12

You must have a user ID to see the references.If you already have a user ID, please click "Login" to access the info.New users can click "Sign Up" to register for an user ID.

Preview

Preview

Codes

  • NII Article ID (NAID) :
    110004820223
  • NII NACSIS-CAT ID (NCID) :
    AA10888815
  • Text Lang :
    ENG
  • Article Type :
    ART
  • ISSN :
    13408054
  • NDL Article ID :
    7387343
  • NDL Source Classification :
    ZN11(科学技術--機械工学・工業)
  • NDL Call No. :
    Z53-Y271
  • Databases :
    CJP  NDL  NII-ELS  J-STAGE