Research on Spindle and Machining Process Monitoring for Intelligent Machine Tools(Advanced machine tool)

• MATSUBARA Atsushi

  Department of Micro Engineering, Graduate School of Engineering, Kyoto University

• SUGIHARA Motoyuki

  Department of Micro Engineering, Graduate School of Engineering, Kyoto University

• SARHAN Ahmed A. D.

  Department of Precision Engineering, Graduate School of Engineering, Kyoto University

• SARAIE Hidenori

  Technology R&D

• IBARAKI Soichi

  Department of Micro Engineering, Graduate School of Engineering, Kyoto University

• KAKINO Yoshiaki

  Kakino Research Institute

抄録

This paper describes a monitoring method of the cutting forces for end milling process by using displacement sensors. Four eddy-current displacement sensors are installed on the spindle housing of a machining center so that they can detect the radial motion of the rotating spindle. Thermocouples are also attached to the spindle structure, and the stability of the displacement sensing is examined. The change in spindle stiffness due to the spindle temperature and the speed is investigated as well. Finally, monitoring results of small and medium scale cutting forces in end milling operations are shown as a case study.

収録刊行物

• Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21

  Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 2005.2 (0), 469-474, 2005

  一般社団法人 日本機械学会

キーワード

• End milling
• Cutting force
• Machine tool
• Monitoring
• Displacement
• Spindle

詳細情報

• CRID: 1390001205900868096
• NII論文ID: 110006185737
• DOI: 10.1299/jsmelem.2005.2.469
• ISSN: 24243086
• Web Site: https://www.jstage.jst.go.jp/article/jsmelem/2005.2/0/2005.2_469/_pdf
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可