NO<sub><i>x</i></sub>Removal by Pulsed High Current Electron Beam in Combination with Photocatalyst

  • Nakagawa Yoshiro
    Department of Electrical Engineering, Graduate School of Engineering/Faculty of Engineering, Osaka City University, 3-3-138 Sugimoto, Sumiyoshi-ku, Osaka 558-8585, Japan
  • Mannami Atushi
    Department of Electrical Engineering, Graduate School of Engineering/Faculty of Engineering, Osaka City University, 3-3-138 Sugimoto, Sumiyoshi-ku, Osaka 558-8585, Japan
  • Natsuno Hideshi
    Department of Electrical Engineering, Graduate School of Engineering/Faculty of Engineering, Osaka City University, 3-3-138 Sugimoto, Sumiyoshi-ku, Osaka 558-8585, Japan
  • Nishikata Satoshi
    Fuji Electric Corporate Research and Development, Ltd., 2-2-1 Nagasaka, Yokosuka 240-0194, Japan

書誌事項

タイトル別名
  • NOx Removal by Pulsed High Current Electron Beam in Combination with Photocatalyst.

この論文をさがす

抄録

A new flue gas treatment device using a pulsed high current electron beam in combination with a photocatalyst (TiO2) was investigated. When the pulsed electron beam (100 keV, 120 A, 1 μs and 4.7 J/pulse) was injected into the gas chamber with a TiO2 sheet on the inner wall, NOx in a 5% oxygen mixed NO (= 200 ppm)/N2 gas was removed with the energy efficiency of removal as high as 1010 nmol/J at a removal ratio of 83%, in which the amount of NOx removed in 10 min without any radiation, about 25% of the initial NO concentration, was not included in the energy efficiency calculation. The concentration of NO2 was below about 3 ppm in this process, which was a significant characteristic of NOx removal in this device. When the flowing 4% oxygen mixed NO (= 200 ppm)/N2 gas at a flow rate 1.4 L/min was irradiated by successive pulses of the electron beam, the energy efficiency of removal of 864 nmol/J at the removal ratio of 41% was obtained.

収録刊行物

被引用文献 (2)*注記

もっと見る

参考文献 (18)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ