Sodium Mefenamate as a Solution for the Formulation and Dissolution Problems of Mefenamic Acid

Sodium salt formation of mefenamic acid (MA) was studied as a way to solve the formulation and dissolution problems of MA. For this purpose, sodium salt of mefenamic acid (Na-MA) was prepared by reacting MA powder with equimolar sodium hydroxide in an aqueous phase, and consequently, Na-MA solution was obtained. The resultant solution was lyophilized and Na-MA powder was collected. The salt formation was confirmed by the results of fourier transformation-infrared (FTIR) spectroscopy and differential scanning calorimetry (DSC) studies on Na-MA powder in comparison to MA powder. Na-MA powder was assessed for direct compressibility, in comparison to MA powder, when formulated as a mixture with minimum amount of Avicel^[○!R] pH 101 and then compressed into tablets using a hydraulic tablet press. Na-MA tablets exhibited satisfactory hardness and friability, and did not show capping or lamination. On the other hand, some MA tablets showed capping or lamination upon compression and all the tested MA tablets for friability capped. Na-MA tablets were also studied for drug dissolution, in comparison to MA tablets, in water, a pH 7.4 phosphate buffer, and a pH 7.4 phosphate buffer after soaking in 0.1 M HCl. Under these different dissolution conditions, Na-MA tablets showed much higher dissolution rate and extent than MA tablets. The results of the study suggested that Na-MA can be considered as a solution form for the formulation and dissolution problems of MA.