123 ボールエンドミルによる多軸制御切削加工における被削物除去状態の幾何的解析(OS-1 切削加工)

• 金子 順一

  埼玉大

• 堀尾 健一郎

  埼玉大

書誌事項

タイトル別名

• 123 Geometric Analysis of Workpiece Removal on Cutting Edge of Ball End Mill for Multi Axis Control Machining

抄録

This study deals with geometric analysis of workpiece removal in multi axis control machining with ball end mill. In order to predict both surface roughness and accuracy of workpiece shape in finish machining process, it is required to apply a new estimation method which can cope with quite small feed rate in cutting conditions. So, in this study, we introduce the developed removal model of workpiece, which is designed to consider influences of cutting edge roundness. And, we analyze both removal depth on each cutter mark and cutting error on workpiece shape, for a case of ball end mill with a throwaway chip. From results, we can find that distribution of removal depth on cutter mark is strongly influenced by tool posture and shape error caused by tool deflection is often bigger than height of cusps.

収録刊行物

• 生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会

  生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会 2006.6 (0), 177-178, 2006

  一般社団法人 日本機械学会

キーワード

• 5-axis control machining
• ball end mill
• cutting error
• surface roughness
• cusp
• tool mark
• cutting edge roundness

詳細情報

• CRID: 1390282680877626496
• NII論文ID: 110006638956
• DOI: 10.1299/jsmemmt.2006.6.177
• ISSN: 24243094
• Web Site: https://www.jstage.jst.go.jp/article/jsmemmt/2006.6/0/2006.6_177/_pdf
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可