C305 ANALYSIS OF PERFORMANCE EFFECT OF HEAT SOURCE TEMPERATURE ON SILICA GEL-WATER ADSORPTION CHILLER(Heat Pump-2)
-
- MA Xinling
- School of Chemical Engineering, Zhengzhou University
-
- WEI Xinli
- School of Chemical Engineering, Zhengzhou University
-
- MENC Xiangrui
- School of Chemical Engineering, Zhengzhou University
-
- YAO Yao
- School of Chemical Engineering, Zhengzhou University
抄録
Through experimental research of the performance effect about the heat source temperature to silica gel-water adsorption chiller, the results obtained show that with temperature increasing refrigerating output will grow, but increment rate is variational; and when the heat source temperature rises, the variety of COP is a wave curve, so COP value comes into being two wave crests and two troughs. With further studies on the microstructure and shape of silica gel, the investigation proves that the micropore of silica gel is mostly "inkbottle" shape, and the distribution of micropore diameter is well-regulated. The results show the adsorption-desorption hysteresis should be sufficiently taken into account when designing or appraising the silica gel-water adsorption chiller. It is also indicated that the micropore diameter of silica gel would match with heat source temperature when designing the experiment.
収録刊行物
-
- Proceedings of the International Conference on Power Engineering : ICOPE
-
Proceedings of the International Conference on Power Engineering : ICOPE 2009.3 (0), _3-163_-_3-165_, 2009
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205886293248
-
- NII論文ID
- 110008064108
-
- ISSN
- 24242942
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可