書誌事項
- タイトル別名
-
- S1105-1-3 Multi Optimum Design for Thrust Bearing with Weight Factor as a Design Variable Consideration
抄録
The machine tends to low energy and high efficiency. It was mainly used for oil bearing. Then, it is important that it improve the bearing performance to raise the performance of the rotational machinery. To such a problem, it was studied optimum design to improve characteristics of bearing in recently. In general, when it performed the bearing design, it was performed as multipurpose optimum design to optimize a number of objective functions at the same time. Previously, when it solve multipurpose optimum design problem, it give weight factor to each objective function, it was boil down to single objective function for the summation. However, in fact, to select weight function, it decided for try and error or judgment of value of designer. Therefore, there are problems to need the calculation number of times and take a lot of calculation time to get the optimum weight factor. In this paper, it studies about optimum design of groove geometry for thrust bearing with weight factor consideration.
収録刊行物
-
- 年次大会講演論文集
-
年次大会講演論文集 2010.4 (0), 183-184, 2010
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206063361408
-
- NII論文ID
- 110008700229
-
- ISSN
- 24331325
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可