2114 分割線の付加による製品の易解体性設計手法の提案(第2報) : 干渉領域に基づいた分割線付加位置決定支援(OS7-1 設計方法論の新展開,OS7 ライフサイクル設計とサービス工学)

DOI Web Site

書誌事項

タイトル別名
  • 2114 Proposal of a Design Method for Dismantling with Split-Lines (2nd Report) : Determination of the location of split-lines based on interference region

抄録

An important process for the reuse and recycling of end-of-life products is their disassembly. In general, manual disassembly is a labor intensive and costly process. Especially, removing fasteners takes time and cost. This paper proposes a design method for the disassembly of products with split-lines, which enable to destruct a poduct into desired shapes like pull tabs of cans and caps of PET bottles. This method supports a designer to add split-lines to the products in the design phase in order to extract a target component. Especially, this paper proposes a method for determining the location of split-lines by detecting interference regions between components. A case study shows that the dismantling of a LCD TV with split-lines reduces the number of manual operations needed for extracting a target component.

収録刊行物

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ