ICOPE-15-1010 Improvement of a cooling method for suction air of combined cycle power plants using water spray and its application to working plants

DOI Web Site

抄録

This paper reports output increase of combined cycle power plants by cooling their suction air using water spray nozzles, in order to deal with tight supply-demand situation of electricity and to save fuel consumption. The splay nozzles installed previously are pointing to downstream of air flow or downward. We tried to improve its cooling efficiency by optimize the spray nozzle angle. Laboratory experiments were conducted for that purpose. Suction air area was 2 meter square, and air flow velocity was set to approximately 2 meter/sec.by a blower. Temperature and related humidity were set to 33 centigrade and 60 percent respectively by air-conditioning units. As a result, a method that the splay nozzles are pointing upstream of air flow showed the best performance. The same tendency was also observed by finite element analysis using a CFD program. This method was applied at both a working combined cycle power plant of 380 MW and that of 500 MW on trial. Temperature of cooled air was measured using a number of thermocouples in suction air room at each plant. Consequently, it was observed that the cooling efficiency was improved by ten percent and several percent respectively, and plant output was increased by approximately 2 MW at the 380 MW plant.

収録刊行物

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ