Direct Patterning of Ceramic Circuit Board with Q-Switched Nd:YAG Laser

• Uno Yoshiyuki

• Kubota Shin-ichiro

• Nakajima Toshikatsu

• Ogata Kojiro

• Tada Nobuhiko

抄録

Direct patterning of copper coated ceramic circuit board is experimentally investigated with Q-switched Nd:YAG laser in order to shorten the time of the trial manufacture of electronic circuit board and to adapt the flexible design change. It is pointed out that the fast direct patterning the speed of which reaches about 100 mm/s is possible if the repetition frequency and the average power are selected properly. Furthermore cutting off and/or drilling of ceramic board are also possible under the condition that the repetition frequency is less than 3kHz. This technique makes it possible the mask1ess patterning of ceramic circuit board which has been widely used recently in place of conventional glass-epoxy or phenolic resin circuit board, and it leads to the shorter time limit of delivery as compared with the conventional end-milling method.

収録刊行物

• Memoirs of the Faculty of Engineering, Okayama University

  Memoirs of the Faculty of Engineering, Okayama University 27 (1), 1-10, 1992-11-25

  Faculty of Engineering, Okayama University

詳細情報

• CRID: 1390853649478291200
• NII論文ID: 120002307702
• NII書誌ID: AA10699856
• ISSN: 04750071
• DOI: 10.18926/15385
• Web Site: https://ousar.lib.okayama-u.ac.jp/15385
• 本文言語コード: en
• データソース種別:
  • JaLC
  • IRDB
  • CiNii Articles