Compression and Recovery Property for Metal Gasket with Straight Sections and Arc Sections
-
- CHEN Dai-Heng
- Department of Mechanical Engineering, Tokyo University of Science
-
- KARATSU Kouji
- 東京理科大学工学部
-
- MASUDA Kenichi
- 東京理科大学工学部
-
- HARUYAMA Shigeyuki
- 山口大学大学院技術経営研究科
Bibliographic Information
- Other Title
-
- 直線部分と円弧部分を有するメタルガスケットの圧縮特性と復元特性
Abstract
In this study, compression and recovery properties for metal gasket with straight sections and arc sections are studied by using the finite element method (FEM). When a metal gasket is subjected to clamp load, a contact width which is necessary for seal-up occurs due to flattening of the arcs. Then, the combination of the straight sections and the arc sections causes various deformation modes because the combination has a large effect on the characteristic of flattening. In other words, it is possible to control the flattening behaviour by adjusting the stiffness of the straight sections and the arc sections. Based on these facts, it is possible to propose a metal gasket in which the flattening occurs at the clamp load and the dent does not occur, furthermore, the clamp load does not descend very much at the tiny looseness.
Journal
-
- TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
-
TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A 77 (782), 1701-1711, 2011
The Japan Society of Mechanical Engineers
- Tweet
Details 詳細情報について
-
- CRID
- 1390001204477830656
-
- NII Article ID
- 130001423272
-
- ISSN
- 18848338
- 03875008
-
- HANDLE
- 10110/00018103
-
- Data Source
-
- JaLC
- IRDB
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed