高炭素溶銑からの直接固相製鋼法の可能性検討<br>‐急速凝固した高炭素を含有する溶銑薄板の脱炭‐

DOI Web Site Web Site 参考文献13件

書誌事項

タイトル別名
  • Feasibility of Solid-State Steelmaking from Cast Iron<br>-Decarburization of Rapidly Solidified Cast Iron-
  • 高炭素溶銑からの直接固相製鋼法の可能性検討 : 急速凝固した高炭素を含有する溶銑薄板の脱炭
  • コウタンソ ヨウセン カラ ノ チョクセツコソウ セイコウホウ ノ カノウセイ ケントウ : キュウソク ギョウコ シタ コウタンソ オ ガンユウ スル ヨウセン ハクバン ノ ダッタン
  • Feasibility of Solid-State Steelmaking from Cast Iron -Decarburization of Rapidly Solidified Cast Iron-

この論文をさがす

抄録

To meet the unprecedented demand of environmental issues and tightened production cost, steel industry must develop the disruptively innovative process. In the present study, totally new steelmaking process of ‘Solid State Steelmaking’ (or S3 process) without BOF process, or liquid state oxidation process is proposed. The overview of the new process is as follows: (1) High carbon liquid iron is directly solidified by strip casting process to produce high carbon thin sheets. (2) Then, the produced cast iron sheet is decarburized by introducing oxidizing gas of H2O or CO2 in a continuous annealing line to produce low carbon steel sheets. The most beneficial aspect of the S3 process is the elimination of several steps such as BOF, and secondary refinement processes and no formation of inclusions. To investigate the feasibility of S3 process, the cast iron strips with various high carbon content produced by a centrifugal slip casting method are decarburized at 1248K and 1373K by using H2O-H2 gas mixture and its kinetics of the decarburization is investigated. In the decarburization process, the carbon diffusion through the decarburized austenite phase but not the decomposition of cementite is the rate controlling step of the decarburizing process. It is found that 0.5 mass% C sheets can be produced from 3.89 mass% C sheets with the thickness of 1.0 mm within 30 min at 1373K. Based on these results, S3 process is confirmed to be feasible as an alternative low cost steelmaking process although the further improvement of the process will be necessary.

収録刊行物

  • 鉄と鋼

    鉄と鋼 98 (5), 151-160, 2012

    一般社団法人 日本鉄鋼協会

参考文献 (13)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ