Development of Tension Meter for Wire Rope and Lashing Belt

• DAIFUKU Satoshi

  Oita University

• LI Bei

  Toshiba Logistics

• YAMAGUCHI Yasuaki

  Toshiba Logistics

• NAGATOSHI Masuji

  Oita University

• IMADO Keiji

  Oita University

抄録

Wire rope and lashing belt are conveniently used in many places without knowing their tension. From the view point of safety, it is important to know the magnitude of their tension to avoid accident. We developed a tension meter for wire rope and lashing belt of a post-mountable type by which the magnitude of their tension in use can be evaluated. The tension meter twists a small part of the target and evaluates the torque required for a twist. So far, it has been unclear where to set a reference point for twist angle due to an internal friction of the wire rope. In this study, the reference point can be determined automatically by an electric control system so as to charge the same twist angle onto the wire rope. Regarding the lashing belt, there is no need to control the reference point as it has little internal friction. It was confirmed in the experiments that there was a linear relation between the tension and twisting torque in both wire rope and lashing belt. In addition, the internal friction of wire rope is discussed using a simple model.

収録刊行物

• Journal of Mechanical Systems for Transportation and Logistics

  Journal of Mechanical Systems for Transportation and Logistics 6 (1), 65-72, 2013

  一般社団法人 日本機械学会

キーワード

• Wire Rope
• Lashing Belt
• Tension Meter
• Twisting Torque
• Stepping Motor
• Electric Control
• Internal Friction

詳細情報

• CRID: 1390282680263193344
• NII論文ID: 130003369125
• DOI: 10.1299/jmtl.6.65
• BIBCODE: 2013JMSTL...6...65D
• ISSN: 18821782
• Web Site: https://www.jstage.jst.go.jp/article/jmtl/6/1/6_65/_pdf
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可