Characteristics of Link-Type Cubic Anvil, High Pressure-High Temperature Apparatus

• Wakatsuki Masao

  Toshiba Research and Development Center, Tokyo Shibaura Electric Co., Ltd.

• Ichinose Kazuaki

  Toshiba Research and Development Center, Tokyo Shibaura Electric Co., Ltd.

• Aoki Toshio

  Toshiba Research and Development Center, Tokyo Shibaura Electric Co., Ltd.

抄録

Operational characteristics are investigated for evaluation and improvement of a high pressure apparatus which has a new anvil-driving mechanism. Analysis and measurement of anvil motion reveales that a very accurate anvil-alignment is achieved and maintained throughout hundreds of usages. Pressures are generated up to 100 kbar with avils having square faces 10 mm on an edge, and 120 kbar with anvils having square faces 6.4 mm on an edge. A method is devised to correct the effect of elastic deformation in structural parts, and completely isotropic compression is realized. Temperatures higher than 2000°C are attained in samples, 4 mm in diameter and 8 mm in length, while anvil-temperatures do not exceed 300°C. Operational ease and long anvil-life in the apparatus are attributed to the new anvil driving mechanism.

収録刊行物

• Japanese Journal of Applied Physics

  Japanese Journal of Applied Physics 10 (3), 357-366, 1971

  The Japan Society of Applied Physics

キーワード

• General Physics and Astronomy
• General Engineering

詳細情報

• CRID: 1390282681241968640
• NII論文ID: 210000016116
• NII論文ID: 130003459074
• DOI: 10.1143/jjap.10.357
• ISSN: 13474065
• ISSN: 00214922
• ISSN: http://id.crossref.org/issn/00214922
• Web Site: https://iopscience.iop.org/article/10.1143/JJAP.10.357
• Web Site: https://iopscience.iop.org/article/10.1143/JJAP.10.357/pdf
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可