スリット溶接部の拘束応力・ひずみについて

DOI Web Site 被引用文献2件

書誌事項

タイトル別名
  • Restraint Stresses-Strains in Slit Weld
  • スリット ヨウセツブ ノ コウソク オウリョク ヒズミ ニ ツイテ

この論文をさがす

抄録

Relating to cold cracking in steel welds, restraint stresses and strains are studied theoretically for the slit weld, in which a slit is made in an infinitely large plate and welding is done into the slit. Restraint of weld will be higher at the ends than at the middle part of the slit. Assumptions used in the analysis are that 1) welding heat is given instantaneously along the length of a slit and 2) throat thickness of weld is rather small as compared with the plate thickness. These assumptions are enable us to make elastic analysis concerning stress-strain in the plate even when general yielding occurs in the weld metal. According to a model considered for obtaining the restraint severity in the weld metal along a slit, restraint deformations in the weld are given by the sum of the elastic movement of the slit edges at elevated temper atures and the contraction of weld metal. Plastic part of the restraint deformations will be a measure of restraint severity in slit weld. It is obtained along a slit as functions of variables such as length of slit, thickness of plate, weld heat input, yield strength of the material etc. General yielding in the wed metall occurs over a certain length near the ends of a slit. The restraint deformation or restraint strain become maximum at a location apart the value of critical plate thickness, or 15-20 mm in shielded-metal-arc-welinbg of steels, from the ends of a slit. Examples of them are calculated for steel welds.

収録刊行物

  • 溶接学会誌

    溶接学会誌 45 (4), 309-315, 1976

    一般社団法人 溶接学会

被引用文献 (2)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ