書誌事項
- タイトル別名
-
- Control of Welding Distortion in Fillet Welds of Aluminum Alloy.
抄録
In this study, a new method to control the welding distortion of fillet welds which is especially substantial in thin aluminum alloy was proposed. This is the method to effectively reduce the angular distortion during the welding process, which is conducted by TIG heating on the back surface of welding plate going ahead of MIG welding arc. The advantage of this method was experimentally demonstrated, because it was confirmed that the angular distortion could be completely reduced by this method in comparison with the TIG heating applied before and after welding.<BR>By using a thermo-elastic-plastic FEM, the main effect of the TIG heating preceding to MIG welding on the decrease of angular distortion was analyzed. Consequently, the large reduction of angular distortion by this method resulted from the two main effects. One effect is that the TIG heating on back surface provides reverse angular distortion by thermal strain. Another one is the preheating effect, which is provided as a result of pre-set temperature distribution of the plate in thickness direction by the TIG heating and the following MIG welding. Accordingly, the decrease of angular distortion sensitively depends on the condition of TIG heating, such as the distance from MIG to TIG torch, the TIG heat input and the width of TIG heat source. In order to maintain the reduction effect stably, keeping a distance to some extent between TIG and MIG torch is more effective. But, it is necessary to select appropriate TIG heat input.
収録刊行物
-
- 溶接学会論文集
-
溶接学会論文集 17 (2), 301-309, 1999
一般社団法人 溶接学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282679698738560
-
- NII論文ID
- 130003764593
-
- ISSN
- 24348252
- 02884771
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可