書誌事項
- タイトル別名
-
- Fabrication and properties of ceramic dispersed aluminum alloy composites by powder liquid forming technique.
- フンマツ エキソウ セイケイホウ ニ ヨル セラミックス ブンサンガタ アルミ
この論文をさがす
抄録
A new type fabrication process for particles dispersed composites, powder liquid forming technique, was proposed. In this process, first compacts blended of air atomized aluminum alloy powders and ceramic particles were produced by cold press. The obtained compacts were heated up to the melting point of matrix aluminum alloy and pressed in the mold in order to wet between the molten metal and the ceramic particles, and then formed under pressure. The fabrication conditions of this process were investigated mainly from the density and Vickers hardness of Al2O3 particles/6061 powder composites. The forming temperature needed over the melting point of matrix and the forming pressure over 80MPa. 0.2% proof stress increased with volume fraction of Al2O3 particles. The elastic moudulus of T6 heat treated Al2O3 particles/6061 powder composites, Ec, could be expressed as<br>Ec=178Vf+72(GPa)<br>where Vf is the volume fraction of particles.
収録刊行物
-
- 軽金属
-
軽金属 39 (4), 255-261, 1989
一般社団法人 軽金属学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681316805248
-
- NII論文ID
- 130004208882
- 10003793652
-
- NII書誌ID
- AN00069773
-
- COI
- 1:CAS:528:DyaL1MXltVWgs7k%3D
-
- ISSN
- 18808018
- 04515994
- http://id.crossref.org/issn/04515994
-
- NDL書誌ID
- 3236161
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可