書誌事項
- タイトル別名
-
- Electrical discharge machining characteristics of Ti-6Al-4V alloy.
- Ti 6 Al 4 V ゴウキン ノ ホウデン カコウ トクセイ
この論文をさがす
抄録
In order to reveal the electrical discharge machining (EDM) of titanium alloy, a series EDM tests on commercial product Ti-6Al-4V with graphite and copper used as the tool electrode materials were carried out at different parameters such as discharge current and pulse duration. The relationships between these factors and material removal rate, surface roughness, enlargement and heat-affected layer were investgated. The following main results were obtained. From the view point of metal removal rate using graphite electrode with negative polarity is remarkably larger than the copper electrode. But from the view point of surface roughness copper electrode is better than graphite electrode. The thickness of heat-affected layer increases with increasing pulse duration and discharge current, especially, when the pulse duration is large enough, the heat-affected layer becomes severely.
収録刊行物
-
- 軽金属
-
軽金属 42 (11), 644-649, 1992
一般社団法人 軽金属学会
- Tweet
キーワード
詳細情報
-
- CRID
- 1390001206335987968
-
- NII論文ID
- 130004209167
- 10003795289
-
- NII書誌ID
- AN00069773
-
- COI
- 1:CAS:528:DyaK3sXltVWgsrk%3D
-
- ISSN
- 18808018
- 04515994
- http://id.crossref.org/issn/04515994
-
- NDL書誌ID
- 3798574
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可