書誌事項
- タイトル別名
-
- Wear Property of Harmonic-Structured Material with High Speed Steel and Mild Steel Produced by MM/SPS Process
- MM/SPS プロセス ニ ヨリ サクセイ シタ ハイスコウ/タンソコウ フクゴウ チョウワ ソシキ ザイリョウ ノ マモウ トクセイ
この論文をさがす
抄録
The harmonic-structured material that consists of a network fine grain region with a high speed steel and a dispersed coarse grain region with a mild steel was fabricated prepared using a mechanical milling and spark plasma sintering process. The wear properties of harmonic-structured materials with the high speed steel volume fraction of 15.4 to 30.0 % were evaluated by the wear test of the ball-on-disk type. The wear property for Vickers hardness of the harmonic-structured material with the high speed steel volume fraction of 30.0 % is superior to various materials such as ferrous, non-ferrous materials and ceramic materials. The wear surfaces of the harmonic-structured materials were observed by the scanning electron microscope and laser microscope. The wear surface observation of harmonic-structured materials reveals that the wear property of the harmonic-structured material depends on the volume fraction of the high speed steel network region. The superior wear property of harmonic-structured material needs approximately 30.0 % of high speed steel volume fraction.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 62 (6), 302-307, 2015
一般社団法人 粉体粉末冶金協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681286598656
-
- NII論文ID
- 130005084735
-
- NII書誌ID
- AN00222724
-
- ISSN
- 18809014
- 05328799
-
- NDL書誌ID
- 026563130
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可