P-10 自走式破砕機による広葉樹チップ化の生産性と減容効果

DOI

書誌事項

タイトル別名
  • P-10 Productivity of chipping using a mobile chipper and effect of chipping on volume reduction of hardwood branches

抄録

<p>As the energy use from woody biomass is increased woody biomass supply from softwood logs only may not be sufficient. The necessity of cutting hardwood trees such as oak is now increasing because of an increase in the damage caused by Japanese oak wilt. Therefore, it is anticipated that the use of hardwood as woody biomass will increase. However, it is difficult to construct an efficient supply system because few data are available on the harvesting and transportation of hardwood materials. In this study, hardwood branches with low carrying efficiency were chipped to reduce the volume, and its rate of volume reduction and the chipping productivity was measured. We found that the chipping productivity was 5.5 t-dry/hour (9.7 t-wet/hour, 30.4 chip-m3/hour) with a 60 mm hole screen, 3.6 t-dry/hour (6.2 t-wet/hour, 18.4 chip-m3/hour) with a 40 mm hole screen, and 3.0 t-dry/hour (5.2 t-wet/hour, 14.9 chip-m3/hour) with a 25 mm hole screen. The bulk density of the branches of the hardwood tree is 0.08 t-dry/m3, and after chipping, it became 0.19 t-dry/m3, and the rate of volume reduction was 41%.</p>

収録刊行物

詳細情報 詳細情報について

  • CRID
    1390001205786325760
  • NII論文ID
    130005296173
  • DOI
    10.20550/jiebiomassronbun.12.0_69
  • ISSN
    24238341
    24238333
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ