書誌事項
- タイトル別名
-
- The cutting behaviour observation of the artificial hair by oscillation and rotation shaver
抄録
<p>The shaver is a popular electronic utility for male to cut their beard, hair and so on. It is roughly divided two shaving system as oscillating or rotating motion of an inner blade. The cutting hairs mechanism is also assumed that inner blade edge just cut hairs at the moment of contact between inner blade and hairs. However, the hairs were likely to pull into the shaver and a pulling force generated which we felt in use. The detail cutting motion and pulling force was observed and measured to clarify the differences between oscillation and rotation type by a high speed camera. Each shaving system showed same tendency that the inner blade penetrated to the hair at the first, then both the inner blade and hair moved together to the outer blade. Finally, the inner and outer blade cut the hair by scissor action with pulling force generation simultaneously. As regards oscillation shaver, it was indicated that the inner blade hit the hair several times before the hair was completely cut. The maximum pulling force was approximately 0.15 N and the average was 0.04 which was higher than rotation type of 0.13 N as maximum and 0.03 N as average. Finally, the relation between the inner blade speed and pulling force of rotating type shaver was investigated, and the rotating type showed lower pulling force generation nevertheless of its lower inner blade speed (1.18 m/s) than oscillation type (2.3 m/s).</p>
収録刊行物
-
- 日本機械学会論文集
-
日本機械学会論文集 82 (844), 16-00187-16-00187, 2016
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680491738112
-
- NII論文ID
- 130006943457
-
- ISSN
- 21879761
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可