微生物を担持させた石こう-ホタテ貝殻系水質浄化材の作製

書誌事項

タイトル別名
  • Fabrication of Microorganism-Supported Gypsum- Scallop Shell Water Purification Ceramics
  • ビセイブツ オ タンジサセタ セッコウ : ホタテ カイガラケイ スイシツ ジョウカザイ ノ サクセイ

この論文をさがす

抄録

<p>Recently, phosphorus and organic substances are the origin of water pollution and have caused various diseases in closed area. Therefore it is essential to establish a method for the removal of phosphorus and organic substances in waste water. In this study, we attempted to support microorganism onto gypsum-calcium carbonate composite bodies and discussed the removal properties for phosphorus and organic substances. Microorganisms were supported on the gypsum-scallop shell composite bodies by immersing a culture solutions containing saccharomyceto, bacillus natto and lactobacillus for various time. The effects of particle size of scallop shell powder and immersing time in the culture solution were investigated on the removal properties for phosphorus and organic substances. The removal performance for organic substances of the gypsum bodies increased with increasing the immersing time in the culture solution. However, the phosphorus removal capacity decayed on immersing in the culture solution. The lowering rate of the phosphorus removal capacity increased with increasing the particle size of scallop shell powder and immersing time in the culture solution. When the amount of adhering microorganism increased, the coarse gained scallop shell exposed on the surface of the gypsum bodies, which act as the site for the precipitation of calcium phosphate, was fully covered with microorganisms. Therefore, the phosphorus removal efficiency drastically decreased on immersing in the culture solution for longer durations. On the other hand, because fine scallop shell powder effectively exposed on the surface, the decreasing rate phosphorus removal capacity was relatively small. There is the optimum at particle size of scallop shell powder and the immersing time of culture solutions in producing phosphorus and organic matter removal properties.</p>

収録刊行物

  • 材料

    材料 66 (6), 383-388, 2017

    公益社団法人 日本材料学会

被引用文献 (3)*注記

もっと見る

参考文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ