|
COVER
Full Text:
CiNii
|
|
|
CONTENTS
Full Text:
CiNii
|
|
|
Fundamental Studies on Cavitation Erosion : Observation of the Eroded Surface by SEM under Corrosive Liquid
Full Text:
CiNii
|
461-467
|
|
Study on Fatigue Fracture of Laminated Inhomogeneous Metals : In Quenched Clad Plates of Low Carbon Steel and Middle Carbon Steel
Full Text:
CiNii
|
468-474
|
|
Fatigue Strength of Low Carbon Steel Plate with a Sharp Notch and a Precrack under Plane Bending at Elevated Temperatures
Full Text:
CiNii
|
475-482
|
|
A Crack Originating from an Angular Corner of a Semi-infinite Plate With a Step
Full Text:
CiNii
|
483-488
|
|
The Torsion of a Hollow Cylinder with Many Internal Circumferential Cracks
Full Text:
CiNii
|
489-494
|
|
On the Relative Coefficients of the Multiaxial Probability Distribution Function for Fracture
Full Text:
CiNii
|
495-500
|
|
Study on the High Speed Rotating Disc Reinforced by Laminating and Hoop Winding Method
Full Text:
CiNii
|
501-506
|
|
Effects of the Change of the Maximum Stress and the Stress Ratio on the Cyclic Creep Behaviors
Full Text:
CiNii
|
507-513
|
|
An Infinite Solid Cylinder under Bending by Concentrated Loads
Full Text:
CiNii
|
514-519
|
|
On the Stress Concentration Problem of a Circular Shaft with a Semicircular Groove Under Tension : An Application of Green's Functions for Body Force Problems of a Solid Cylinder
Full Text:
CiNii
|
520-527
|
|
A Method for Analysis of Elasto-dynamic Contact Problems by Finite Element Method
Full Text:
CiNii
|
528-533
|
|
Ductile Fracture of Carbon Steel under Cold Metal Forming Conditions : 3rd Report, Effects of Deformation Mode and Deformation History on Ductile Fracture Strain
Full Text:
CiNii
|
534-539
|
|
Interference between Boundary Layer Flow and Wake Flow
Full Text:
CiNii
|
540-546
|
|
Reduction of Noise in Roots Blower
Full Text:
CiNii
|
547-554
|
|
Measurement of Pulsating Flow Rate by means of Float-Area-Type Flow Meters
Full Text:
CiNii
|
555-561
|
|
Gas-liquid Two-phase Flow in Double-Tubes-Annular-Passage with Flow Obstruction : 1st Report, Effect of Flow Obstruction on Minimum Film Thickness)
Full Text:
CiNii
|
562-570
|
|
A Study on the Reduction of NO_x of Diesel Engine by the Use of an Auxiliary Injection Method
Full Text:
CiNii
|
571-577
|
|
Analysis of Forced Vibration with Reduced Impedance Method : Part l, Introduction of Analytical Procedure
Full Text:
CiNii
|
578-584
|
|
Basic Research on the Vibratory Travelling Element : Travelling mode and Velocity
Full Text:
CiNii
|
585-590
|
|
Distortions and Residual Stresses of Gears Caused by Hardening : 5th Report, Gear with Limited Face Width
Full Text:
CiNii
|
591-598
|
|
Discussion : On the Three-dimensional Impeller with Loxodromic Curve Blade
Full Text:
CiNii
|
599-600
|
|
Abstracts of Technical Papers
Full Text:
CiNii
|
601-611
|
