Search Results 1-3 of 3

  • 10512 Effects of Surface Profile Smoothing in Laser Multi-pass Dieless Drawing Process of Stainless Steel Microtube  [in Japanese]

    FURUSHIMA Tsuyoshi , FURUSAWA Shusaku , MANABE Ken-ichi

    … Effects of surface profile smoothing in laser multi-pass dieless drawing process are studied experimentally to fabricate microtube of stainless steel. … To investigate the effects of surface profile smoothing, drawing limit and distribution of outer diameter in each pass are measured. …

    The Proceedings of Conference of Kanto Branch 2015.21(0), _10512-1_-_10512-2_, 2015

    J-STAGE

  • 20304 Fabrication of Metal Micro Tubes Using Multi-pass Dieless Drawing Process  [in Japanese]

    FURUSHIMA Tsuyoshi , FURUSAWA Shusaku , TSUSHIMA Kei , IMAGAWA Yusuke , MANABE Ken-ichi

    … Fabrication of stainless steel microtubes by multi-pass dieless drawing process is studied experimentally. … Effect of heating temperature and tube thickness on drawing limit is investigated in 1-Pass dieless drawing to determine suitable conditions for fabrication of microtubes. …

    The Proceedings of Conference of Kanto Branch 2013.19(0), 261-262, 2013

    J-STAGE

  • Dieless drawing process of extruded non-circular aluminum alloy tubes with double hollow section  [in Japanese]

    FURUSHIMA Tsuyoshi , MANABE Ken-ichi

    Dieless drawing technique can thin down tubes by combining locally heating and tensile deformation of tubes without dies and tools. … In this study, the dieless drawing process is applied to non-circular 1100 and 3003 aluminum alloy extruded tubes with double hollow section for heat exchangers. … Fundamental deformation behavior of the tubes in the dieless drawing is investigated experimentally. …

    Journal of Japan Institute of Light Metals 57(8), 351-356, 2007-08-30

    J-STAGE References (9) Cited by (2)

Page Top