急冷凝固Al-Si系粉末合金の高速超塑性

DOI Web Site Web Site 被引用文献2件 参考文献15件

書誌事項

タイトル別名
  • High Strain Rate Superplasticity of Rapidly Solidified Al-Si Powder Metallurgy Alloys
  • キュウレイ ギョウコ Al Siケイ フンマツ ゴウキン ノ コウソク チョウ

この論文をさがす

抄録

Al-17Si-4.5Cu-0.5Mg-(0∼6)Fe-(0∼2)Mm (Mm: misch metal) rapidly solidified powder metallurgy (RSP) alloys were prepared by the hot extrusion method. High temperature tensile properties and deformation behavior of these alloys at 773 K were investigated. In the Al-17Si-4.5Cu-0.5Mg alloy with various Si particle sizes, typical superplastic behavior is obtained at the same strain rate of 1×10−2 s−1. The superplastic tensile elongation increased with decreasing Si particle size. With increasing Fe content, the average matrix grain size decreased and the optimum superplastic strain rate increased, but the maximum tensile elongation decreased. The grain-size sensitivity on the superplastic strain rate is about 3, as that of other superplastic Al alloys. Misch metal addition has a significant effect of retardation of coarsening of matrix grains by uniformly precipitated Al2(Si, Cu)2RE (RE: Lanthanoid) particles finer than compounds including Fe, and the maximum tensile elongation was obtained at a high strain rate of 1×100 s−1. It is generally concluded that the superplastic elongation of Al-Si RSP alloys is affected by the size of dispersing particulates.

収録刊行物

  • 日本金属学会誌

    日本金属学会誌 61 (11), 1211-1219, 1997

    公益社団法人 日本金属学会

被引用文献 (2)*注記

もっと見る

参考文献 (15)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ