高次機能セラミックスの切削特性

• 森口 秀樹

  住友電気工業(株)伊丹研究所

• 池ケ谷 明彦

  住友電気工業(株)伊丹研究所

• 野村 俊雄

  住友電気工業(株)伊丹研究所

• 宮本 欽生

  大阪大学産業科学研究所

• 栗 振思

  大阪大学産業科学研究所

• 谷畑 公昭

  大阪大学産業科学研究所

書誌事項

タイトル別名

• Cutting Performance of Hyperfunctional Ceramics.
• コウジ キノウ セラミックス ノ セッサク トクセイ

抄録

Al₂O₃-TiC ceramic tools are used for finish machining of cast iron. But these tools break easily in wet cutting. In order to overcome this problem, the cutting performance of hyperfunctional Al₂O₃-TiC ceramic tools with symmetrically graded structures of Al₂O₃/TiC/Ni/TiCAl₂O₃ were studied. Two hyperfunctional ceramic tools with different types of layering were fabricated by SHS/HIP processes. Al₂O₃-TiC ceramic tools with symmetrically graded structure of concentric layers showed good breakage resistance in wet cutting as compared with monolithic Al₂O₃-TiC ceramic tools fabricated using the same process. Numerical calculation using the finite element method (FEM) showed that the Al2O3-TiC ceramic tools with the symmetrically graded structure of concentric layers had strong residual compressive stress at the edge of the tool in the direction parallel to the edge. It seemed that this compressive stress was effective in preventing breakage.

収録刊行物

• 粉体および粉末冶金

  粉体および粉末冶金 42 (12), 1389-1393, 1995

  一般社団法人 粉体粉末冶金協会

キーワード

• Al<SUB>2</SUB>O<SUB>3</SUB>-TiC ceramics tools
• hyperfunction
• symmetrically graded structure
• residual comprssive stress

詳細情報

• CRID: 1390282681284502912
• NII論文ID: 10001750417
• NII論文ID: 10003343760
• NII書誌ID: AN00222724
• DOI: 10.2497/jjspm.42.1389
• ISSN: 18809014
• ISSN: 05328799
• NDL書誌ID: 3635002
• Web Site: https://ndlsearch.ndl.go.jp/books/R000000004-I3635002
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • NDL
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可