根管内ベント設置によるU1trafilによる根管充填法に関する研究  [in Japanese] A Study on the Root Canal Obturation Method by Ultrafil Using a Vent Provided into Root Canal  [in Japanese]

Access this Article

Search this Article

Author(s)

    • 都築 民幸 TSUZUKI Tamiyuki
    • 日本歯科大学歯学部歯科保存学教室第1講座 Department of Endodontics, The Nippon Dental University, School of Dentistry at Tokyo
    • 勝海 一郎 KATSUUMI Ichiroh
    • 日本歯科大学歯学部歯科保存学教室第1講座 Department of Endodontics, The Nippon Dental University, School of Dentistry at Tokyo
    • 鈴木 雄一朗 SUZUKI Yuichiroh
    • 日本歯科大学歯学部歯科保存学教室第1講座 Department of Endodontics, The Nippon Dental University, School of Dentistry at Tokyo
    • 小川 久生 OGAWA Hisao
    • 日本歯科大学歯学部歯科保存学教室第1講座 Department of Endodontics, The Nippon Dental University, School of Dentistry at Tokyo
    • 石井 隆資 ISHII Takashi
    • 日本歯科大学歯学部歯科保存学教室第1講座 Department of Endodontics, The Nippon Dental University, School of Dentistry at Tokyo
    • 中村 恭政 NAKAMURA Yasumasa
    • 日本歯科大学歯学部歯科保存学教室第1講座 Department of Endodontics, The Nippon Dental University, School of Dentistry at Tokyo

Abstract

<p><b>Abstract : </b>The present study was performed to evaluate the influence of vent made in the root canal during root canal obturation using Ultrafil. For the experiment, a root canal model made of polyester resin was used, in which the root canal taper was varied according to the size corresponding to No. 40 of the ISO specification. A 30-gauge injection needle was used as the vent for the root canal, and Ultrafil Regular set was employed as root canal obturation gutta-percha. The obturation status of the root canal was determined by evaluation using x-ray, observation of the continuous cutting surface from 0.5 mm to 6.5 mm of root canal tip every 1 mm, and measurement of the proportion of the gutta-percha area in the cross-sectional area of the root canal (gutta-percha condensing ratio). The conclusions were as follows :</p><p> 1. In case root canal obturation was performed without a vent in the root canal, to which injection nozzle can not be inserted up to the tip of the root canal, gutta-percha was not injected up to the tip of the root canal.</p><p> 2. In case root canal obturation was performed by making a vent in the root canal, to which injection nozzle can not be inserted up to the tip of the root canal, the vent served effectively as the discharge route for the air or the excessive amount of sealer.</p><p> 3. In the root canal model, in which a vent was made in the root canal and obturation was performed, gutta-percha was condensed satisfactorily at all cutting positions of the root canal.</p><p> 4. In the root canal model, in which a vent was made and obturation was performed, there was no influence of the difference of the root canal taper on obturation status, and no difference in gutta-percha the condensing ratio was noted.</p>

Journal

  • The Journal of Japan Endodontic Association

    The Journal of Japan Endodontic Association 16(1), 38-46, 1995-06-30

    Japan Endodontic Association

References:  13

Cited by:  2

Codes

  • NII Article ID (NAID)
    10008153290
  • NII NACSIS-CAT ID (NCID)
    AN10443184
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    13406248
  • Data Source
    CJP  CJPref  J-STAGE 
Page Top