チタンの切削に関する研究 : チタン鋳造冠の除去についての検討  [in Japanese] A Study on Cutting of Titanium : Removal of Titanium Cast Crown  [in Japanese]

Access this Article

Search this Article

Author(s)

    • 吉田 展也 YOSHIDA Nobuya
    • 奥羽大学歯学部歯科補綴学第1講座 The First Department of Prosthodontics, Ohu University School of Dentistry
    • 柳沢 勲 YANAGISAWA Isao
    • 奥羽大学歯学部歯科補綴学第1講座 The First Department of Prosthodontics, Ohu University School of Dentistry
    • 加藤 崇 KATO Takashi
    • 奥羽大学歯学部歯科補綴学第1講座 The First Department of Prosthodontics, Ohu University School of Dentistry

Abstract

The purpose of this study was to clarify the problem in case of removal of the titanium crown from the abutment tooth. The specimens in the shape of simplified full cast crown were produced with pure titanium and Ag-Pd alloy. The specimens were cut using dental turbine with carbide burr, which was used 12 consecutive times. The required time to cut the specimen was measured, and the difference of materials and thickness of specimens were evaluated. Furthermore, the section of burr that was used 12 consecutive times was observed.<BR>The results were as follows:<BR>1. The required time to cut the titanium crown was longer than that of the Ag-Pd alloy crown.<BR>2. In case of cutting the titanium crown, the damage to the carbide burr was extensive compared with Au-Ag-Pd alloy of the same thickness.<BR>From the above, it was suggested that a device for reducing the thickness of the crown was necessary to produce the titanium crown.

Journal

  • Nihon Hotetsu Shika Gakkai Zasshi

    Nihon Hotetsu Shika Gakkai Zasshi 44(1), 100-105, 2000-02-10

    Japan Prosthodontic Society

References:  18

Cited by:  1

Codes

  • NII Article ID (NAID)
    10008154688
  • NII NACSIS-CAT ID (NCID)
    AN00197911
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    03895386
  • Data Source
    CJP  CJPref  J-STAGE 
Page Top