射出成型法によるマイクロ波重合型レジンの機械的性質  [in Japanese] Mechanical Properties of the Injection Type Microwave-cured Resin  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

The purpose of this study was to investigate the degrees of polymerization of denture base resins processed with injection type microwave-cured resin, conventional type microwave-cured resin, and heat-cured resin. The methods for evaluation with the degree of polymerization induced the conditions of the mechanical properties in transverse strength, modulus of elasticity, deflection, water absorption, water solubility, initiation temperature, and maximum temperature. Under the conditions of this study, the resins were compared, and the results were as follows:<BR>1. The mechanical properties of injection type microwave-cured resin were lower than conventional type microwave-cured resin and heat-cured resin.<BR>2. The degree of polymerization of injection type microwave-cured resin was lower than that of conventional type microwave-cured resin and heat-cured resin.

Journal

  • Nihon Hotetsu Shika Gakkai Zasshi

    Nihon Hotetsu Shika Gakkai Zasshi 44(3), 404-409, 2000-06-10

    Japan Prosthodontic Society

References:  16

Cited by:  2

Codes

  • NII Article ID (NAID)
    10008155812
  • NII NACSIS-CAT ID (NCID)
    AN00197911
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    03895386
  • Data Source
    CJP  CJPref  J-STAGE 
Page Top