支台築造と接着 : レジン支台築造法について  [in Japanese] Challenge of Adhesive Resin Core in Coronal Radicular Stabilization  [in Japanese]

Access this Article

Search this Article

Author(s)

    • 福島 俊士 FUKUSHIMA Shunji
    • 鶴見大学歯学部歯科補綴学第2講座 Department of Fixed Prosthodontics, Tsurumi University School of Dental Medicine
    • 坪田 有史 TSUBOTA Yuhji
    • 鶴見大学歯学部歯科補綴学第2講座 Department of Fixed Prosthodontics, Tsurumi University School of Dental Medicine
    • 小久保 裕司 KOKUBO Yuhji
    • 鶴見大学歯学部歯科補綴学第2講座 Department of Fixed Prosthodontics, Tsurumi University School of Dental Medicine

Abstract

Immediately after development of composite resin, it was used not only as filling material but also as the core material. Clearfil core, which came on market in 1980, was widely accepted in dental practice, resulting in many failures because of insufficient bond strength to dentin.<BR>Since then, high polymer science has made rapid progress, and now a lot of adhesive resin core materials are available with high bond strength to dentin. It is time to check the efficiency of these materials in practice.<BR>In this study, each component and its mutual relationship of the composite resin core with prefabricated metal posts were examined. As a result, the resin core with prefabricated posts indicated the same bonding strength as the cast post and core. In addition, core resin could be used as luting materials with better bond strength than conventional adhesive resin cements.

Journal

  • Nihon Hotetsu Shika Gakkai Zasshi

    Nihon Hotetsu Shika Gakkai Zasshi 41(6), 881-887, 1997-12-10

    Japan Prosthodontic Society

References:  31

Cited by:  6

Codes

  • NII Article ID (NAID)
    10008167868
  • NII NACSIS-CAT ID (NCID)
    AN00197911
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    03895386
  • Data Source
    CJP  CJPref  J-STAGE 
Page Top