書誌事項
- タイトル別名
-
- The Study on the Pressure Put by Contacting Basal Surface of Pontic. Part 2. Output Property of Polyvinylidene Fluoride Film under Conditions of Various Pressure.
- Part 2: Output Property of Polyvinylidene Fluoride Film under Conditions of Various Pressure
- 第2報加圧条件の違いによるポリフッ化ビニリデンフィルムの出力特
この論文をさがす
抄録
In case of fixed partial denture cases, how to set the contact state between the applied pontic basal surface of fixed partial denture and the alveolar mucosa is important. Various opinions are presented including slight and noncompression methods. How to confirm the contact state in the mouse depends on the doctor's experience and no established method is available. In determination of the contact pressure between the pontic basal surface and alveolar mucosa, a polyvinylidene fluoride film (PVDF) is continuously used.<BR>In the present study, similar to Report 1, PVDF, previously bonded to pseudomucosa, was tested under various compression conditions using a pressure tool, which simulated the pontic basal surface, to analyze the amount of load in relation to the output voltage of PVDF. The results were as follows:<BR>1. A high correlation was observed between the amount of load added and the output voltage of PVDF irrespective of the pressure condition.<BR>2. By measuring the area surrounded by the PVDF output voltage line and zero-voltage line, it was possible to presume the amount of dynamic load applied to the pseudomucosa.<BR>The results suggested that PVDF can be successfully applied to adjust the pontic basal surface of a fixed partial denture.
収録刊行物
-
- 日本補綴歯科学会雑誌
-
日本補綴歯科学会雑誌 42 (2), 307-313, 1998
社団法人 日本補綴歯科学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204410047616
-
- NII論文ID
- 10008169347
-
- NII書誌ID
- AN00197911
-
- ISSN
- 1883177X
- 03895386
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可