書誌事項
- タイトル別名
-
- A Study on the Load Distribution of the Abutment Teeth and Residual Ridges of a Removable Partial Denture with Cast Clasps. In Comparison with a Conical Crown Retained Denture.
- In Comparison with a Conical Crown Retained Denture
- コーヌステレスコープ義歯との比較
この論文をさがす
抄録
The purpose of this study was to investigate the effects of various retainer designs on the characteristics of stress distribution and vertical dislodgment of the denture base. A mandible simulation model of unilateral distal-extension missing teeth (three teeth from the second premolar to the second molar) was used in this study. A conical crown, Akers clasp, and double Akers clasp were used as retainers.<BR>The results were as follows:<BR>1. The conical crown retained denture produced significantly less stress distribution and vertical dislodgment of the denture base than the two clasp designs.<BR>2. The conical crown retained denture produced the most intense stress on the apical and distal surfaces of the most distal abutment, while the double Akers clasp design produced the least stress.<BR>3. The Akers clasp design produced less load distribution of the denture base and greater vertical stress of the abutment tooth than the double Akers clasp design.<BR>4. The bilateral denture design produced less load distribution of the denture base and greater vertical stress of the abutment tooth.<BR>5. On condition of the bilateral denture design including clasps with a proximal plate, stress and load distribution were similar to those of the conical crown retained denture.
収録刊行物
-
- 日本補綴歯科学会雑誌
-
日本補綴歯科学会雑誌 42 (4), 597-604, 1998
社団法人 日本補綴歯科学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204409224064
-
- NII論文ID
- 10008170324
-
- NII書誌ID
- AN00197911
-
- ISSN
- 1883177X
- 03895386
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可