レーザ溶接による高精度な歯科補綴装置の製作法に関する研究  [in Japanese] Use of Laser Welding for High Precision Dental Prostheses  [in Japanese]

Access this Article

Search this Article

Author(s)

    • 氷見 彰敏 HIMI Akitoshi
    • 大阪歯科大学大学院歯学研究科歯科補綴学専攻 Graduate School of Dentistry (Prosthodontics), Osaka Dental University

Abstract

In this study, the influences of fixation of soldering investment and post-heat treatment after welding on the prevention of the welding deformation were investigated by using a 3-unit bridge.<BR>Moreover, the metal die for the welding and fixation bar were made for trial purposes to gain strong fixation, and they were used in the experiment. In addition, the deformations induced bywelding on a super hard stone model, soldering, and one-piece casting were compared with the result of laser welding.<BR>The conclusions were as follows:<BR>In the laser welding of Ag-Pd-Cu-Au alloy, thebest method of obtaining adental prosthesis with good agreement is post-heat treatment after welding, while its castings are fixed stronglytothemetaldiefor welding.<BR>Moreover, the adaptability of the 3-uni tbridge that was welded by this method wasmoreexcellentthan that of the bridge made by soldering or one-piece casting.<BR>As a result, welding on the super hard stone model was undesirable, because large transverse shrinkage was induced and it was not possible to heat-treat it after welding because it was fixed.

Journal

  • Nihon Hotetsu Shika Gakkai Zasshi

    Nihon Hotetsu Shika Gakkai Zasshi 43(2), 260-268, 1999-04-10

    Japan Prosthodontic Society

References:  15

Cited by:  2

Codes

  • NII Article ID (NAID)
    10008172720
  • NII NACSIS-CAT ID (NCID)
    AN00197911
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    03895386
  • Data Source
    CJP  CJPref  J-STAGE 
Page Top