通常焼結炉で焼結したCrMo合金鋼粉末の特性  [in Japanese] Properties of PM Steel Powders Pre-alloyed with Chromium and Molybdenum, Sintered in Conventional Furnaces  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

The dominating part of mass produced PM-steels today are sintered in continuous furnaces operating at maximum 1150°C. The alloying elements Cu, Ni, Mo and C are normally used to obtain good material properties. However, environmental concerns and cost might restrict the use of especially Cu and Ni, as additives to PM-steels, in the future. Since many years, Cr-alloyed PM-steels are available as complement to the existing Cu/Ni-alloyed materials. This family of materials has many advantages and the most important are cost, the ability to be recycled and hardened. However, still PM part production of Cr-steels is mainly limited to top performance applications sintered at high temperature. In the present paper focus is put on processing Cr-alloyed PM-steels in furnaces operating at maximum 1150°C. It shows necessary precautions to betaken for the successful sintering of PM-steels alloyed with Cr.

Journal

  • Journal of the Japan Society of Powder and Powder Metallurgy

    Journal of the Japan Society of Powder and Powder Metallurgy 49(5), 444-449, 2002-05-15

    Japan Society of Powder and Powder Metallurgy

References:  6

Codes

  • NII Article ID (NAID)
    10008559668
  • NII NACSIS-CAT ID (NCID)
    AN00222724
  • Text Lang
    JPN
  • Article Type
    ART
  • ISSN
    05328799
  • NDL Article ID
    6169546
  • NDL Source Classification
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL Call No.
    Z17-274
  • Data Source
    CJP  NDL  J-STAGE 
Page Top