フロアブルレジン修復物のか壁適合性ならびに諸物性について

DOI 被引用文献9件 参考文献32件
  • 吉川 孝子
    東京医科歯科大学大学院医歯学総合研究科摂食機能保存学講座う蝕制御学分野
  • WATTANAWONGPITAK Nipaporn
    Cariology and Operative Dentistry, Department of Restorative Sciences, Graduate School, Tokyo Medical and Dental University
  • 袁 楊
    東京医科歯科大学大学院医歯学総合研究科摂食機能保存学講座う蝕制御学分野
  • 田上 順次
    東京医科歯科大学大学院医歯学総合研究科摂食機能保存学講座う蝕制御学分野 東京医科歯科大学21世紀COEプログラム歯と骨の分子破壊と再構築のフロンティア

書誌事項

タイトル別名
  • Effect of flowable composite on cavity wall adaptation of composite restorations and mechanical properties

この論文をさがす

抄録

The purpose of this study was to evaluate the effect of flowable composite on the marginal sealing and cavity wall adaptation of composite restorations, and on the hardness, elastic modulus and flexural strength of resin composite. Cylindrical cavities, 1 mm deep and 3 mm in diameter (C-factor= 2.3) were prepared on flat bovine dentin surfaces. The teeth were restored with Clearfil SE Bond adhesive system followed by Photo Clearfil Bright or Filtek Flow composites. The resins were cured with 600 mW/cm2 40 s using experimental light curing unit. After thermocycling, dye penetration tests were carried out. Composite specimens of 2 mm thickness were polymerized in Teflon molds with 600 mW/cm2 40 s using experimental light curing unit. KHN and elastic modulus measurementswere taken at the top and bottom surfaces of each specimen using Knoop Hardness tester and Nano-indentation tester respectively. Composite specimens of 2×2×8 mm were polymerized in Teflon molds, flexural strength were measured using three point bending test. The flowable composite significantly improved adaptation of resin composite to the cavity wall, and flexural strength, bottom surface microhardness and elastic modulus. However, cured resin composite showed significantly lower microhardness compared with the conventional composite.

収録刊行物

  • 接着歯学

    接着歯学 22 (2), 79-86, 2004

    日本接着歯学会

被引用文献 (9)*注記

もっと見る

参考文献 (32)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ