Application of Sequential Quadratic Programming Method to Temperature Distribution Control in Reactor Furnace

Access this Article

Search this Article


    • KONISHI Masami
    • Department of Electrical and Electronic Engineering, Okayama University
    • IMAI Jun
    • Department of Electrical and Electronic Engineering, Okayama University
    • NISHI Tatsushi
    • Department of Electrical and Electronic Engineering, Okayama University


Recently, various studies have been undertaken to examine the inner furnace phenomena of a blast furnace. These studies are limited, however, to the evaluation of furnace performance while a designed method of furnace control remains unfulfilled. This paper proposes a method of estimating temperature distribution in a reactor furnace using boundary data in order to control inner target furnace temperature distribution. Initially, a simplified furnace simulation program for the calculation of inner furnace gas flow, pressure and temperature distribution is developed. Following that, the simulator is used to estimate and control inner furnace temperature distribution. In the estimation, boundary data such as temperature and pressure, measured near a furnace wall, are used in the furnace simulation. Then, for the control of inner furnace temperature distribution, necessary values for gas blowing at the bottom of the furnace and the burden supply at the top of the furnace are used. Both for the estimation and the control of the inner furnace temperature distribution, a sequential quadratic programming method, a method of the iterative optimization, is applied. In our method, an estimation of inner furnace temperature distribution is done as preparation for the determination of furnace control variables. Through numerical experiments, the validity of our method is demonstrated, showing that the temperature distribution in a furnace can be regulated to the desired one after iterative control operations.


  • ISIJ International

    ISIJ International 45(3), 347-355, 2005-03-15

    The Iron and Steel Institute of Japan

References:  10


Page Top