Fabrication of Functionally Graded Ti<SUB>3</SUB>SiC<SUB>2</SUB>–TiC Binary-Phase Material

DOI Web Site Web Site 22 References
  • Tada Shuji
    Materials Research Institute for Sustainable Development, National Institute of Advanced Industrial Science and Technology
  • Murase Kosuke
    Department of Mechanical Engineering, Daido Institute of Technology
  • Hashimoto Hitoshi
    Materials Research Institute for Sustainable Development, National Institute of Advanced Industrial Science and Technology
  • Sun Zheng Ming
    Materials Research Institute for Sustainable Development, National Institute of Advanced Industrial Science and Technology

Bibliographic Information

Other Title
  • Fabrication of Functionally Graded Ti3SiC2-TiC Binary-Phase Material
  • Fabrication of Functionally Graded Ti<SUB>3</SUB>SiC<SUB>2</SUB>&ndash;TiC Binary-Phase Material

Search this article

Abstract

Ti3SiC2–TiC binary-phase material was investigated with the aim of developing a new hard product. The starting material for the synthesis was prepared by compounding raw powders of Ti, Si and TiC at molar ratios of 1:1:x (x=1.8–7.0). The products were synthesized by sintering and the structures of the samples produced were examined. The product obtained was single-phase Ti3SiC2 when x was 2.0 or less and a Ti3SiC2–TiC binary-phase structure when x was more than 2.0. The mass fraction of TiC in the binary-phase structure increased with increasing x. The optimum sintering temperatures for densification were different for the different synthesized structures: the Ti3SiC2 single-phase structure was well densified at up to 1673 K, whereas higher temperature was required to dinsify the Ti3SiC2–TiC binary-phase structure. These results suggest the possibility of producing Ti3SiC2–TiC functionally graded materials. The traveling-zone sintering method permits integrated sintering of materials at variable temperatures. Powder mixtures with TiC contents from 1.8 to 7.0 mole were layered in the same mold and sintered at variable temperatures from 1643 to 1733 K. The synthesized structure was successfully graded, as in the case of individual synthesis of each of the compounds. The hardness of the produced sample showed a tendency to increase with increasing mass fraction of TiC. These results prove that the traveling-zone sintering method has the potential to fabricate functionally graded materials that require variable sintering temperatures.

Journal

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 48 (2), 139-142, 2007

    The Japan Institute of Metals and Materials

References(22)*help

See more

Keywords

Details 詳細情報について

Report a problem

Back to top