書誌事項
- タイトル別名
-
- Effects of Bonding Conditions on Friction Welding Characteristics of Spheroidal Graphite Cast Iron to Austenitic Stainless Steel
- キュウジョウ コクエン チュウテツ ト オーステナイトケイ ステンレス コウ トノ マサツ アッセツ トクセイ ニ オヨボス アッセツ ジョウケン ノ エイキョウ
この論文をさがす
抄録
In this study, spheroidal graphite cast iron (FCD) and austenitic stainless steel (SUS304) were bonded by friction welding method under various rotation conditions and bevel angles in friction surface of the FCD specimen. Rotational speed and friction pressure were constant. The dimensions of the test pieces were 15mm in diameter and 70mm in length respectively. After bonding, tensile test, microstructure and EPMA observation near the bonding zone of each specimen were performed. As a result, tensile strength increased with decreasing area of the deformed layer of spheroidal graphite. In particular, the FCD base metal specimen was found to break at the following welding conditions; friction time of 90s, forge pressure of 90MPa, forge time of 10s, brake timing of 1s, and bevel angle of 8 degrees. On the other hand, the length of the pearlite layer in FCD adjacent to the bonding interface increased with increasing friction time. In SUS adjacent to the bonding interface, precipitation of chromium carbides were observed which was formed, owing to the diffusion of carbon from FCD to SUS.
収録刊行物
-
- 鋳造工学
-
鋳造工学 79 (4), 174-178, 2007
公益社団法人 日本鋳造工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206508626688
-
- NII論文ID
- 10019508890
-
- NII書誌ID
- AN10514770
-
- COI
- 1:CAS:528:DC%2BD2sXlvFehtLo%3D
-
- ISSN
- 21855374
- 13420429
-
- NDL書誌ID
- 8786946
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可