書誌事項
- タイトル別名
-
- Shape Analysis of Multi-layer Parison at the Pinch-off Process in Extrusion Blow Molding
- タソウ オシダシ ブロー セイケイ ノ ピンチオフ コウテイ ニ オケル パリソン ケイジョウ ノ テイリョウ カイセキ
この論文をさがす
抄録
The shape of a multi-layer parison at the pinch-off process in extrusion blow molding was experimentally and quantitatively analyzed by a rapid cooling method. The multi-layers used in this study were composed of HDPE as inner and outer layers and LDPE with lower viscosity by five times than HDPE as a middle layer. The results obtained in this study are as follows;<BR>1) The land region of a mold has no effects on the parison shape at the pinch-off process.<BR>2) The clearance between knives for pinch-off has significant influence on the parison shape. In particular the clearance from 0 mm to 0.1 mm shows remarkable effects on each layer thickness of the parison.<BR>3) In proportion to the decrease of the clearance, the thickness ratio of the middle layer increases owing to the fluidity difference between HDPE and LDPE.
収録刊行物
-
- 成形加工
-
成形加工 21 (4), 217-222, 2009
一般社団法人 プラスチック成形加工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204462722816
-
- NII論文ID
- 10024747327
-
- NII書誌ID
- AN10278882
-
- ISSN
- 18837417
- 09154027
-
- NDL書誌ID
- 10224783
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可