鋼材-アルミニウム材の異種金属の植込み接合 : フランジ付軸部品の植込み接合法の開発 第2報  [in Japanese] Indentation Joining Process for Steel Bar-Aluminium Plate : Development of Plastic Joining Method Using Indentation II  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

A new plastic joining method for fixing bars with a hot-forged plate was proposed, in which steel bars maintained at room temperature are directly indented into a high-temperature steel plate, as reported in a previous paper. To examine the validity of the developed plastic joining method, the optimum conditions of the plastic joining method are investigated using an SCM435 steel bar and an A5052 aluminium plate on a mechanical or AC servo-controlled press. It is possible to indent the bar to the plate without the buckling or plastic deformation of the bar at room temperature, and the attained shear bonding stress of the bar–plate is approximately 70% of the shear strength of the plate material. The bonding mechanism of the proposed plastic joining method is discussed from the viewpoints of plate seizure and mechanical clamping associated with the process.

Journal

  • Journal of the Japan Society for Technology of Plasticity

    Journal of the Japan Society for Technology of Plasticity 50(581), 550-554, 2009-06-25

    The Japan Society for Technology of Plasticity

References:  4

Cited by:  4

Codes

  • NII Article ID (NAID)
    10024981170
  • NII NACSIS-CAT ID (NCID)
    AN00135062
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    00381586
  • NDL Article ID
    10355022
  • NDL Source Classification
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL Call No.
    Z17-218
  • Data Source
    CJP  CJPref  NDL  J-STAGE 
Page Top