書誌事項
- タイトル別名
-
- Development of Model Materials<br>for Physical Forming Simulation of Metals and Alloys
- キンゾク セイケイ カコウ ジッケン シミュレーションヨウ モデル ザイリョウ ノ カイハツ
この論文をさがす
抄録
In conjunction with experimental simulation of metal forming, the development of model materials, by which forming simulation can be carried out at a low stress level at room temperature, was performed. The model materials are mixtures of microcrystalline wax, rosin, mineral oil and powder. The flow curves of the model materials show three typical configurations, i.e., work softening type, steady state deformation type and work hardening type, which are observed in metals and alloys. The above configurations of the flow curves of the model materials could be changed and controlled by adjusting powder content. The flow curves of the model material could be predicted accurately using the work hardening rate equation determined in this work. As an application example, experiments on and visio-plasticity analyses of the plane strain backward extrusion of Mg alloy and its model material, which represent the deformation property of work-softening-type materials, were carried out. We confirmed that the material flow and strain conditions in both materials correspond to each other with sufficient accuracy for engineering purpose.
収録刊行物
-
- 塑性と加工
-
塑性と加工 51 (593), 582-586, 2010
一般社団法人 日本塑性加工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206498300800
-
- NII論文ID
- 130004488230
- 10026453041
-
- NII書誌ID
- AN00135062
-
- COI
- 1:CAS:528:DC%2BC3cXptlSjtb4%3D
-
- ISSN
- 18820166
- 00381586
-
- NDL書誌ID
- 10755443
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可