Zr基バルク金属ガラスのガラス遷移温度以下の温度におけるクリープ変形挙動  [in Japanese] Creep Deformation Behavior at Temperature Less than Glass Transition Temperature in Zr-Based Bulk Metallic Glass  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

  Bulk Metallic Glasses (BMGs) have high strength, high fatigue limit and high fracture toughness. However, the creep property at temperatures enough less than the glass transition temperature (<i>T</i><sub>g</sub>) has not been examined yet, although it is needed for practical uses. Therefore, in this report, the creep test under a constant load in the atmosphere at comparatively low temperature less than the <i>T</i><sub>g</sub> {573 K(<i>T</i>/<i>T</i><sub>g</sub>=0.84) and 473 K (<i>T</i>/<i>T</i><sub>g</sub>=0.69)} was carried out using the Zr<sub>55</sub>Cu<sub>30</sub>Al<sub>10</sub>Ni<sub>5</sub> at% BMG. As the result, typical creep curves just like as ones in the crystalline alloys were shown, that is, there were transient, steady state and accelerated creeps, and creep strain rate increased with increasing the test temperature and load. The creep deformation occurred uniformly along the parallel part. Just before the break, a necking occurred and several shear bands came at the region due to induced high stress, and finally fractured along those shear bands in the direction of about 50 degrees for the loading axis like as the tensile fracture in the BMG. The specimen surface was oxidized and got into hard ZrO<sub>2</sub>. In the ZrO<sub>2</sub> layer, many cracks were observed. However, in the inner region eliminating the oxide layer, no cracks, no shear bands and on the fracture surface typical vein patterns were observed. Therefore, it was presumed that the uniform creep deformation along the parallel part occurred through a viscous flow under the equilibrium state maintained glass structure.<br>

Journal

  • Journal of the Japan Institute of Metals and Materials

    Journal of the Japan Institute of Metals and Materials 74(9), 614-621, 2010-09-01

    The Japan Institute of Metals and Materials

References:  11

  • <no title>

    FUJITA K.

    Rev. Adv. Mater. Sci. 18, 137-139, 2008

    Cited by (1)

  • <no title>

    FUJITA K.

    J. Metastable Nanocryst. Mater. 24-25, 323-326, 2005

    Cited by (1)

  • <no title>

    SHIROTA A.

    J. Soc. Mater. Sci., Japan 59, 118-123, 2010

    Cited by (1)

  • <no title>

    MIYAJIMA N.

    New Ceramics 35, 1994

    Cited by (1)

  • <no title>

    MASUMOTO K.

    Materials Science of Amorphous Metals, 1982

    Cited by (1)

  • <no title>

    TAIRA S.

    High-temperature Strength of Materials 39, 1980

    Cited by (1)

  • <no title>

    INOUE A.

    Nature Mater. 2, 661-663, 2003

    Cited by (8)

  • <no title>

    GILBERT C. J.

    Appl. Phys. Lett. 71, 476-478, 1997

    Cited by (11)

  • <no title>

    INOUE A.

    Mater. Trans., JIM 36, 1184-1187, 1995

    Cited by (11)

  • <no title>

    KAWAMURA Y.

    Appl. Phys. Lett. 69, 1208-1210, 1996

    Cited by (12)

  • <no title>

    KAWAMURA Y.

    Scr. Mater. 37, 431-436, 1997

    Cited by (18)

Codes

  • NII Article ID (NAID)
    10026599557
  • NII NACSIS-CAT ID (NCID)
    AN00062446
  • Text Lang
    JPN
  • Article Type
    ART
  • ISSN
    00214876
  • NDL Article ID
    10804578
  • NDL Source Classification
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL Call No.
    Z17-314
  • Data Source
    CJP  NDL  J-STAGE 
Page Top