Trial of a CAD/CAM system for fabricating complete dentures

• KANAZAWA Manabu

  Complete Denture Prosthodontics, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University

• INOKOSHI Masanao

  Complete Denture Prosthodontics, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University

• MINAKUCHI Shunsuke

  Complete Denture Prosthodontics, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University

• OHBAYASHI Naoto

  Oral and Maxillofacial Radiology, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University

抄録

The purpose of this study was to evaluate the fabrication of a complete denture using a CAD/CAM system. Cone beam CT was used to measure the complete denture and the artificial teeth. After a 3D complete denture image was structured using 3D CAD software, we factored out the artificial teeth and obtained a 3D denture base image. A machining center cut an acrylic resin block, and fabricated an acrylic complete denture base. The artificial teeth were bonded to the cut denture base using resin cement. A 3D digitizer digitized the fabricated acrylic denture. We measured the deviations between the master 3D complete denture image and the 3D data of the fabricated acrylic denture. The average deviations from the master 3D image were 0.50 mm for the occlusal surface. This present study indicates that it is possible to fabricate a complete denture using a CAD/CAM system.

収録刊行物

• Dental Materials Journal

  Dental Materials Journal 30 (1), 93-96, 2011

  一般社団法人　日本歯科理工学会

キーワード

• Complete denture
• CAD/CAM
• Fabricating accuracy

詳細情報

• CRID: 1390282679693031296
• NII論文ID: 10027421242
• NII書誌ID: AA10443149
• DOI: 10.4012/dmj.2010-112
• ISSN: 18811361
• ISSN: 02874547
• Web Site: https://www.jstage.jst.go.jp/article/dmj/30/1/30_2010-112/_pdf
• Web Site: https://search.jamas.or.jp/link/ui/2012000031
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可